Directions For Use
DO NOT apply directly onto animals or on areas that can be reached or licked by animals.
Agita™ 100 Plus Fly Spray and Paint-on.
Applications rates are as follows:
Dairies, feedlots, abattoirs, piggeries, poultry facilities, horse stables, and kennels.
Commercial areas, industrial and domestic areas.
|Paint-on: 200 g/160 mL lukewarm water
|Spot-Spraying: 200g/ 1.6 L of water = 40 m2 ground or 80-120 m2 wall surface
Add the required amount of the product to water and stir well to ensure suspension. If the mixture is allowed to stand for longer than 30 minutes, stir well before using. Use mixture on the day of preparation, preferably immediately after preparing.
Do not treat dirty, very porous or newly whitewashed walls.
Elanco recommends that Agita™ be used as part of an integrated fly control program. Integrated fly control involves sanitary and management practices to complement chemical control methods consisting of adulticides and larvicides. The following practices help eliminate potential fly breeding sites:
- DO NOT apply or spray product or other non-specific insecticide onto manure as this may inhibit biological control
- Repair leaks that contribute to wet manure (undesirable odour and an ideal breeding site for flies)
- Ensure good site drainage
- Ensure good ventilation of treated facilities
- Ensure any other fly-infested animal operations in close proximity do not act as a source of invading flies
- Promptly remove broken eggs and dead birds from poultry facilities
Cattle, pigs, horses and dogs can remain in buildings being treated provided care is taken to ensure the product is not applied directly to the animals. To avoid chemical residues due to animals licking treated surfaces, always apply to surfaces beyond the reach of animals.
Remove poultry when treating poultry facilities. Paint a minimum of 30 ‘spots’ of about 10 x 30 cm where flies congregate or settle, e.g. warm and sunny wall areas, window frames, milk pipes, outside of feeding troughs. Where insufficient space is available for painting or where slight discolouration would be unacceptable, paint strips of cardboard, polyethylene or light boards and hang them from the ceiling.
200 g Agita™ 100 Plus in 160 mL water is sufficient to treat a building of approx. 80 m2 floor area or 160-240 m2 wall and ceiling surfaces.
Re-treat as required.
Thoroughly mix 400 g of Agita™ 100 Plus in 3.2 litres of lukewarm water in a knapsack sprayer for a building with a floor area of 80 m2 or a corresponding wall/ceiling area of 160-240 m2, of which only about 30% should be treated directly. Surfaces on which flies are particularly likely to settle, such as warm and sunny areas, stall walls; windows, etc. should be sprayed.